Wild Birds Small Birds Feeder Glass Window Mount Type Woodworking Handmade ⑦

This bird feeder is made from yakisugi (charred cedar) wood.
Example photos of its use are shown at the end.

It can be easily attached and detached from your window using suction cups.
To attach, slightly wet the surface where the suction cup will be placed.
To remove, insert a thin object like a cutter between the suction cup and the glass to detach it easily.

The food container is detachable for easy cleaning.
A hole is also provided on the room side, allowing you to observe the birds through the hole from inside your room.

The hole has a diameter of approximately 11cm and comes with a plastic dish. You are welcome to replace it with another item of your choice.
(For reference) Each suction cup has a load capacity of 300g.

★The item will be disassembled for shipping as shown in the photos, so assembly will be required by the customer.
Since it is disassembled for shipping, you can easily reassemble it by aligning the three screws with the pre-drilled holes and tightening them gradually with a Phillips head screwdriver.

★If you wish to have the item assembled before shipping, the price will be 1500 yen, which is 550 yen higher due to increased shipping costs.

★The suction cups will be attached to all four locations before shipping.
They are screwed in through the suction cup holes to allow for replacement.

Approximate dimensions of the assembled product are as follows:
Height: approx. 20cm
Depth: approx. 23cm
Width: approx. 14.5cm
Hole diameter: approx. 11cm

This is a handmade item by an amateur DIY enthusiast, so it may not be perfect, but it has been made with the utmost care.
We hope you will enjoy using it.