⭐︎Pickup Only Special Price⭐︎ 2 HP Boat - Exact Familia FRP Livewell Specification

This is a listing for an Exact Familia FRP livewell version hull + floats.

After purchasing it used, I repaired and reinforced the hull bottom (using FRP material) and restored the floats (reinforced with a rubber solvent).

The previous owner applied silicone waterproofing to the joint of the flip-up dolly and other metal parts.

I used it in the sea with a 2 HP outboard motor, and there were no water leaks. Due to the floats extending from the stern to the bow, you can even stand and cast in calm waters.

Although not shown in the first two photos, a seat board can be attached to the stern, and a folding swivel chair is attached to the seat board.

I did not use it as I sat directly on the hull.

*See photo 3.

I own a Honda Vamos, and I was able to load the entire setup, including the hull and outboard motor, into the Vamos.

Initially, I had prepared FRP reinforcement materials (glass + reddish-purple solvent + white top coat + necessary tools for application) worth approximately ¥10,000 to increase the strength of the hull bottom. However, due to the following circumstances, I have decided to sell it, so I will include them as a bonus, unopened.

■Specifications■
Overall Length: 2,460mm
Overall Width: 1,130mm
Overall Height: 400mm
Storage Dimensions (when disassembled): 129cm x 113cm x 45cm
Weight: 39Kg
Capacity: 2 adults
Applicable Engine: 1.0 HP to 2.5 HP
Transom Height: S (Short)

Included Accessories:
- 2 connecting pins
- Lid
- 1 seat board
- Transom board

Other Accessories:
- High-pressure foot pump
- Rod holder (installed by previous owner)
- Transducer pole
- Flip-up, flat-free tire dolly (removable)
- Oars (left and right)

*Outboard motor is not included.

I am flexible with inquiries and consultations.

As this is a large item, I will offer a discount if you can pick it up.