Archery Line Marking Tool

This is the same product as another listing, so the photos and description are identical.
This is a tool for drawing lines on archery arrows.
It is 3D printed.

The triangular part holds the nock, allowing you to draw lines at 120-degree intervals.
The black O-ring can be used to hold the arrow in place and prevent it from shifting by hooking it into the groove.

It is designed to accommodate commercially available rulers (see second image).
If you don't have a ruler, you can use the thin, perforated part as a substitute (see third image).
The markings are spaced at 5mm intervals.
We've made it so you can manage even without markings on your ruler.

Additionally, grooves are provided across the entire range for drawing names (see fourth image).

We have confirmed compatibility with Easton G-nocks and Biter Outsert nocks.
The arrow shown in the photo is an A/C/E (670, 5.1mm diameter) with a G-nock.
Arrows of equivalent or smaller diameter than A/C/E can be used. (On the drawing, it's up to 6mm diameter, but due to tolerances, it should work up to about 5.8mm diameter.)